In the history of technology, computers and calculators were innovative developments. They are essentially different from all other machines because they have a memory. This memory stores instructions and information. In a calculator, the instructions are the various functions of arithmetic, which are permanently remembered by the machine and cannot be altered or added to. The information consists of the numbers keyed in.

An electronic pocket calculator can perform almost instant arithmetic. A calculator requires an input unit to feed in numbers, a processing unit to make the calculation, a memory unit, and an output unit to display the result. The calculator is powered by a small battery or by a panel of solar cells. Inside is a microchip that contains the memory and processing units and also controls the input unit, which is the keyboard, and the output unit, which is the display.

The input unit has keys for numbers and operations. Beneath the key is a printed circuit board containing a set of contacts for each key. Pressing a key closes the contacts and sends a signal along a pair of lines in the circuit board to the processing unit, in which the binary code for that key is stored in the memory. The processing unit also sends the code to the display. Each key is connected by a different pair of lines to the processing unit, which repeatedly checks the lines to find out when a pair is linked by a key.

The memory unit stores the arithmetic instructions for the processing unit and holds the temporary results that occur during calculation. Storage cells in the memory unit hold the binary codes for the keys that have been pressed. The number codes, together with the operation code for the plus key,   are    held    in    temporary    cells    until    the    processing    unit    requires them. When the equals key is pressed, it sends a signal to the processing unit. This takes the operation code-for example, addition-and the two numbers being held in the memory unit and performs the operation on the two numbers. A full adder does the addition, and the result goes to the decoder in the calculator's microchip. This code is then sent to the liquid crystal display unit, which shows the result, or output, of the calculation.

In what part of the calculator are the processing and memory units? 

Câu hỏi liên quan

• Which of the following is closest in meaning to the word “tuck” in line 11?

• The word “Once” in the fourth paragraph is closest in meaning to ______.

• Which of the following is mentioned as the main cause of the destruction of Mantle’s body?

ZUNIA12

• According to the passage, which type of memory is the shortest?

• Which of the following could be considered a cause of the distress signals of trees?

• What do the Hindu people think about marriage?

• The word "dampened" in the passage is closest in meaning to _____.

• The word ‘monumental’ in Paragraph 2 means __________.

• The word “feasibility” in paragraph 1 is closest in meaning to ...............

• Which of the following terms is defined in the passage?

• According to the reading passage, how did Joseph Pulitzer appeal to the average reader?

• What does “its” in line 5 refer to?

• Who opposed the bill that was introduced in the House of Commons in the early 1900s?

• In the 2^nd paragraph, what weakness in nineteenth-century histories does the author point out?

• The phrase “more achievement oriented” in the paragraph 6 is closest in meaning to ______.

• Students who continue studying at university after having graduated are called .........

• The word "they" in the last paragraph refers to ...............

• The phrase “in season” in line 1 refers to ________ .

• The word “emerged” means ...............

• The researcher mentioned in the passage are concerned about unwanted noise because it can_________.